Power connector – HP 110 User Manual
Page 81
Power connector
Description
Spare part number
Power connector
656095-001
Before removing the power connector, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
).
5.
).
6.
Disconnect the hard drive cable from the system board (see
).
7.
Disconnect the WLAN antenna cables from the WLAN module (see
).
8.
Disconnect the WWAN antenna cables from the WWAN module (see
9.
Remove the following components:
a.
Keyboard (see
).
b.
Top cover (see
c.
Display assembly (see
).
d.
System board (see
).
Remove the power connector:
1.
Loosen the tabs (1) that secure the power connector to the base enclosure.
Component replacement procedures
73