HP 110 - Manual (Page 58)

4. Remove the battery (see Battery on page 44 ).
5. Remove the service door (see Service door on page 45 ).
Remove the RTC battery:
1. Lift the edge (1) of the battery from the system board.
2. Remove the RTC battery (2) from the socket on the system board.
Reverse this procedure to install the RTC battery. When installing the RTC battery, be sure the “+”
sign faces up.
Hard drive
NOTE: The hard drive bracket is included in the Hard Drive Hardware Kit, spare part number
651899-001.
Description Spare part number
Hard drive:
500 GB, 9.5 mm (0.37 in) × 6.35 cm (2.50 in), parallel SATA, 5400-rpm (select models only) 634932-001
320 GB, 9.5 mm (0.37 in) × 6.35 cm (2.50 in), parallel SATA, 5400-rpm 622643-001
250 GB, 9.5 mm (0.37 in) × 6.35 cm (2.50 in), parallel SATA, 5400-rpm 622641-001
320 GB, 7.0 mm (0.28 in) × 6.35 cm (2.50 in), parallel SATA, 5400-rpm 645193-001
250 GB, 7.0 mm (0.28 in) × 6.35 cm (2.50 in), parallel SATA, 5400-rpm 645191-001
Hard Drive Hardware Kit 651899-001
50 Chapter 4 Removal and replacement procedures