Henny Penny OFE-321 - Manual (Page 9)

Model OFE-321,322
1-4. WARNINGS AND The controls monitor procedure problems and system failures
ERROR MESSAGES with warnings and error codes. The display shows the
warning or error code, and an alarm sounds.
Pressing cancels most warnings and pressing any
control button stops most error code alarms. But there are
some exceptions (see below). The display shows the error
until the situation is corrected.
WARNINGS
DISPLAY CAUSE CORRECTION
“W-1” Incoming supply voltage too low Have voltage at plug and receptacle checked
“LOW
VOLTAGE”
“W-2” Faulty components or connections Have elements, connections, and contactors
“SLOW checked
HEAT-UP”
“W-3” Product loaded into frypot Wait until shortening is at proper temperature
“WAS NOT before lights before loading product
READY”
“W-4” Too much product Do not overfill frypot
“SLOW in frypot
COOKING”
“W-5 Product loaded into frypot Wait until shortening is at proper temperature
“SLOW before lights before loading product
COOKING”
“W-6” Faulty components or connections Have elements, connections, and contactors
“SLOW checked
COOKING”
“W-7” Faulty components or connections Have elements, connections, and contactors
“LOW AMPS” checked
“W-9” Product overcooked. (may Discard product immediately
“DISCARD appear after a “SLOW COOKING”
PRODUCT” warning)
“OIL TOO Didn’t allow shortening to drop Cancel button stops this warning; once the
HOT” to current product’s setpoint shortening drops to setpoint temperature,
temperature the alarm automatically stops
405
1-5