Heath Zenith Motion Sensing Diecast Lantern SL-4190 Series - Manual (Page 5)

5 595-5628-08
COMPLETE THE INSTALLATION
❒ Stuff the wires into the junction box. Make
sure none of the wires get pinched.
Slide the fixture onto the
mounting screws and
tighten nuts.
❒ Install one 100 Watt maximum light bulb, or
three 60 Watt bulbs in candelabra style.
❒ Install the fixture top. Secure with
decorative screws.
❒ After completing the tests on page 5, caulk
fixture mounting surface with silicone
weather sealant.
Junction
Box
Model 4193 Glass Installation
❒ Model 4193 only: install the six pieces
of glass by sliding them down as shown.
The glass panels should rest upon the
corner guides on each side, and against
the rubber bumpers at the bottom.
Note: As with any glass, handle with care.
Corner
Guides
Rubber Bumpers