beautypg.com

Test and adjustment, Specifications – Heath Zenith DUAL BRITE SL-5318 User Manual

Page 3

background image

598-1001-01

3

Motion

Motion

8 ft.

(2.4 m)

70 ft.

100 ft.

(21 m) (30.5 m)

Boosted

Sensor

240

°

B

O

O

S

T

MAX

MIN

RANGE

ON - TIME

DUAL BRITE

TEST 1 5 2 0

MINUTES

OFF 3 6 DUSK TO

HOUR DAWN

TEST AND ADJUSTMENT

Turn on the circuit breaker and light switch.

NOTE:

Sensor has a 1

1

/

2

minute warm up period

before it will detect motion. When first turned
on, wait 1

1

/

2

minutes.

Bottom of Sensor

Avoid aiming the control at:

• Objects that change temperature rapidly, such as

heating vents and air conditioners. These heat
sources could cause false triggering.

• Areas where pets or traffic may trigger the control.

Nearby large, light-colored objects reflecting light

may trigger the shut-off feature. Do not point other
lights at the sensor.

Turn the RANGE control to the mid position, Dual
Brite™ to OFF and the ON-TIME control to the
TEST position.

Maximum

Maximum Range

Coverage Angle

The detector is less sensitive to motion directly towards it.

Least Sensitive

Most Sensitive

SPECIFICATIONS

Horizontal Range . . . Up to 70 ft. (21 m); 100 ft.

(30.5 m) with Range Boost.
[varies with surrounding
temperature]

Sensing Angle . . . . . . Up to 240

°

Electrical Load . . . . . . Up to 300 Watt Maximum In-

candescent [Up to 150 Watt
Maximum each lamp holder.]

Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and MANUAL

MODE

Time Delay . . . . . . . . 1 , 5, 20 minutes
Dual Brite™ Timer . . . 3, 6 hours, Dusk-to-Dawn

Warning - Risk of fire. Do not aim the lamps at a
combustible surface within 3 ft. (1 m).

Loosen the clamp screw in
the sensor ball joint and gen-
tly rotate the sensor.

Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cov-
erage area. Keep the sen-
sor at least 1" (2.5 cm) away
from the lamps.

Adjust the RANGE as
needed. RANGE set too high
may increase false triggering.

Secure the sensor head by
tightening the clamp screw.
Do not overtighten the screw.

Set the amount of TIME you
want the lights to stay on after
motion is detected (1, 5, or 20 minutes).

Set the DUAL BRITE™ switch to the amount of
time after dusk you want the lights on at low level
(Off, 3, 6 Hrs., Dusk-to-Dawn).

Clamp
Screw

Ball
Joint

Aim Sensor

Down for Short

Coverage

Aim Sensor

Higher for Long

Coverage

DESA Specialty Products™ reserves the right to dis-
continue products and to change specifications at any
time without incurring any obligation to incorporate new
features in products previously sold.