Hearth and Home Technologies CARODG36I - Manual (Page 13)

Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. X • 6/13 13
A. IntelliFire Plus™ Pilot Ignition System Wiring
• This appliance is equipped with an intermittent pilot ignition
(IPI) control which operates on a 6-volt system.
• This appliance is supplied with a battery pack which is
located in the control box. A wiring diagram is shown in
Figure 6.1.
• The battery pack requires four batteries (not included).
•
An optional electric kit is available. This allows the system
to be operated with 110/120 VAC instead of batteries. See
Section 6.B.
• The appliance comes standard with an OFF/ON switch
on the control box lid
• Optional RC100 wireless wall switch (OFF/ON). For use
only with the optional electric kit.
• Optional RC200 wireless remote allows fl ame adjustment
(AUX200 is not required since there is no fan used). For
use only with the optional electric kit.
6 6
Electrical Information
Figure 6.1 Intermittent Pilot Ignition (IPI) Wiring Diagram - Battery Power Only
WARNING! Risk of Shock! Replace damaged wire with
type 105° C rated wire. Wire must have high temperature
insulation.
WARNING! Risk of Shock! Label all wires prior to discon-
nection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation
after servicing.
NOTICE: RC100 & RC200 must be protected from the
elements.
• The module should be in the REMOTE position. Putting
the switch in the OFF position will disable all fi replace
controls.
Hearth & Home Technologies recommends that IntelliFire
Plus
TM wireless controls be used for their features and
functionality with the IntelliFire Plus TM ignition system.
External Control Switch
(Isolates batteries from system to increase battery life)
Valve
Module
Pilot
assembly
Wiring
harness
Jumper
wire
Battery
holder
RED
RED
RED
BRN
BLK
BLK
GRN
ORG
ORG
WHT
RED
BLK