Hearth and Home Technologies Cyclone-Cust - Manual (Page 31)

Heat & Glo • Cyclone-Cust • 2061-900 Rev. L • 10/08 31
12 12
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included
with accessories. See Service Parts List for appropriate
accessories. Refer to Section 15.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING
D. Glass Assembly Installation
Figure 12.3 Once the glass cylinder is centered, while
pushing down, twist the glass cylinder clockwise to en-
gage the locking hooks. Turn the glass cylinder counter-
clockwise while pushing down to remove.
Figure 12.1
Figure 12.2 Position the bottom of the glass assembly by
centering it on the platform as shown.
LOCKING
HOOKS