Hughes DIRECWAY AN4-074-DF - Manual (Page 48)

Chapter 4 • Cabling and connections
32
1035567-0001 Revision A
Routing the cables at
the ODU Route the coaxial transmit and receive cables at the ODU as
follows:
1. Route the transmit cable (marked with blue electrical tape) to
the back of the transmitter in a configuration similar to that
shown in Figure 30.
2. Route the receive cable (marked with red electrical tape) up
the mast, behind the reflector, and through the feed arm to the
LNB to achieve a configuration similar to that shown in
Figure 30.
Figure 30: Transmit and receive cable configurations
T0145004
Transmitter
Transmit cable
(marked with
BLUE tape)
Receive cable
(marked with
RED tape)
Receive cable
passes through
feed arm.
LNB