beautypg.com

3 setting the configuration, 1 enter the administrator mode, 3 setting the configuration -3 – Hitachi GR2000-B Series User Manual

Page 37: 1 enter the administrator mode -3

background image

Basic Operations

GR2K-GA-0008

3-3

Rev. 1.00

3.3

Setting the Configuration

This section explains about how to configure the GR2000-B for operation.

Here is some detailed information about the each of the settings.

3.3.1

Enter the Administrator Mode

3.3.2

Enter the Configuration Edit Mode (Begin Editing the Configuration)

! HQDEOH

FRQILJXUH

FRQILJ RSHQ

FRQILJ OLQH /$1 HWKHUQHW

FRQILJ OLQH /$1 HWKHUQHW

FRQILJ LS /$1

FRQILJ LS /$1

FRQILJ VWDWLF GHIDXOW JDWHZD\

FRQILJ VKRZ

OLQH /$1 HWKHUQHW

OLQH /$1 HWKHUQHW

LS /$1 ^

`

LS /$1 ^

`

VWDWLF ^

GHIDXOW JDWHZD\

`

FRQILJ VDYH

FRQILJ FORVH

FRQILJ H[LW

H[LW

!

(5) A default route is set.

(6) The information configured is dispayed.

The information displayed as a
result of the configuration.

(1) The system enters the administrator mode.
(2) The system enters the configuration edit mode.
(3) The configuration file is opened.
(4) IP address is set for the Ethernet port.

(7) The configuration information is saved.
(8) The configuration file is closed.
(9) The system goes out of the configuration edit mode.
(10) The system goes out of the administrator mode.

! HQDEOH

The system is switched to the
administrator mode by the
enable command.

The # prompt is used in the
administrator mode.

! FRQILJXUH

FRQILJ

The system is switched to the
configuration edit mode by the
configure command.

The (config)# prompt is shown.