Hitachi GR2000-B Series - Manual (Page 35)

GR2K-GA-0008 3-1
Rev. 1.00
Chapter 3
Basic Operations
This chapter shows examples of the commands required for connecting the
GR2000-B to other devices. The chapter contains the following sections:
„ Configuration examples
„ Startup of the GR2000-B
„ Configuration setting
„ Display of the operation status
„ Details about the commands introduced in this chapter
„ More details about the operation
3.1 Configuration Examples
Using the example below, this section explains about the simple method of setting
configurations.
Figure 3-1 Example of a GR2000-B Connecting to Other Devices
To construct the configuration above in Figure 3-1, set the GR2000-B according to
the following instructions:
„ Set IP address "192.168.1.1" for PORT 0 of the GR2000-B built-in Ethernet.
„ Set IP address "192.168.2.1" for PORT 1 of the GR2000-B built-in Ethernet.
„ Set IP address "192.168.2.2" for a default route (in case that the IP address
"192.168.2.2" is set for the port of the peer router.)
Built-in Ethernet
Port
IP 192.168.2.1
Built-in Ethernet
Port 0
IP
192.168.1.1
GR2000-B Server
PC
PC
PC
PC
Network A Network B Network C
Peer Router