Heath Zenith BL-1800 - Manual

© 2007 HeathCo LLC 598-1321-01
Motion Sensor Light
Control
Model BL-1800
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with a junction box
marked for use in wet locations.
• The backplate has knockouts so the sensor can be
mounted on most junction boxes.
• In some applications a universal adaptor plate may
be needed. Adaptors are available at home centers
and electrical supply stores.
Cover
Plate
Light Control
Lamp Holders
Sensor
2 Wire
Connectors
Gasket
4 Mounting
Screws (2 sizes)
This package includes:
OPERATION
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1 1 /
2
minutes for
the circuitry to calibrate.
MANUAL MODE
ON-TIME
10 TEST
10 TEST
ON-TIME
TEST
... back on.
AUTO
1 Second OFF
then...
Put the ON-TIME switch in the 10
minute position.
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the ON-
TIME switch in the 10 position.
Move ON-TIME Switch to
10 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
As an ENERGY STAR ® Partner, Heath ® /Zenith
has determined that this product meets the EN-
ERGY STAR
® guidelines for energy efficiency.
This product is ENERGY STAR ® compliant
when used with 120 Watt bulbs.
Mode: On-Time Works: Day Night
Test 5 Seconds x x
Auto 10 Min x
Manual Until Dawn* x