HP 3800 - Manual (Page 69)

There are three steps to set up custom paper. When all are completed, the display returns to the PAPER
HANDLING menu. After a custom size is set for a tray, the printer retains the setting until you change
it in the control panel.
x
y y
1
2
1 X dimension
2 Y dimension
Unit of measure
1. Press to highlight UNIT OF MEASURE, and then press .
2. Press or to highlight the correct measurement, and then press .
X dimension
The X dimension is the width of the page as it feeds into the printer.
1. Press to highlight X DIMENSION, and then press .
2. Press or to highlight the correct value, and then press .
Y dimension
The Y dimension is the length of the page as it feeds into the printer.
1. Press to highlight Y DIMENSION, and then press .
2. Press or to highlight the correct value, and then press .
Configuring tray 2 or tray 3 for custom paper
The printer automatically detects many sizes of paper, but you can also configure trays for custom paper
sizes. You must specify the following parameters:
● Unit of measure (millimeters or inches)
● X dimension (the width of the page as it feeds into the printer)
● Y dimension (the length of the page as it feeds into the printer)
ENWW Configuring trays 55