HP 3800 - Manual (Page 60)

3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to select CONFIG METHOD.
7. Press to highlight MANUAL, and then press .
8. Press to highlight MANUAL SETTINGS, and then press .
9. Press to highlight SUBNET MASK, and then press .
10
. Press the or arrow to increase or decrease the number for the first byte of the subnet mask.
11
. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
12
. Repeat steps 10 and 11 until the correct subnet mask is entered, and then press to save the
subnet mask.
13
. Press Menu to return to the Ready state.
Setting the default gateway
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to select CONFIG METHOD.
7. Press to highlight MANUAL, and then press .
8. Press to highlight MANUAL SETTINGS, and then press .
9. Press to highlight DEFAULT GATEWAY, and then press .
10
. Press the or arrow to increase or decrease the number for the first byte of the default
gateway.
11
. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
12
. Repeat steps 10 and 11 until the correct default gateway is entered, and then press to save the
default gateway.
13
. Press Menu to return to the Ready state.
46 Chapter 3 I/O configuration ENWW