HP 3800 - Manual (Page 61)

Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● Decreases printer-generated network traffic
● Prevents unauthorized users from printing to the printer
● Provides only pertinent information on the configuration page
● Allows the printer control panel to display protocol-specific error and warning messages
To disable IPX/SPX
NOTE Do not disable this protocol in Windows-based systems that print to the printer using
IPX/SPX.
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight IPX/SPX, and then press .
6. Press to select ENABLE.
7. Press to highlight OFF, and then press .
8. Press Menu to return to the Ready state.
To disable AppleTalk
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight APPLETALK, and then press .
6. Press to select ENABLE.
7. Press to highlight OFF, and then press .
8. Press Menu to return to the Ready state.
To disable DLC/LLC
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
ENWW Network configuration 47