Setting the scsi id number, Setting the scsi id number -10 – Epson 1600 User Manual
Page 34
2-10
Setting Up the Scanner
R4C0910
Rev. C
A5 size
SETUP.FM
1/12/00
Pass 3
L
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Setting the SCSI ID number
The scanner's default SCSI ID number is 2.
If you add the scanner to a system in which one of your SCSI devices
already has a SCSI ID of 2, change the ID number to an unused
number using the rotary switch. See the table below as a guide.
ID
Availability
Description
0
Not available for Macintosh
Used for hard disk
Not recommended for Windows
Usually used for hard disk
1
Not recommended
Usually used for hard disk
2
Factory setting of the scanner
3
Not available if your Macintosh
has a built-in CD-ROM
4
5
6
7
Not available for Macintosh
Always used for the Macintosh
itself
May not be available for Windows
Usually used for the SCSI board
✽
Not available
For transportation purposes.
*
* Scanner will not work if selected.
The SCSI ID rotary switch
is located at the rear of
the scanner.