Bosch 800 Series 30 Inch Double Speed Combination Smart Electric Wall Oven Owners Manual - Manual (Page 20)

20
5. Follow the instructions in the app.
6. Wait until "NETWORK CONNECTED" is shown on the
display.
The connection may fail. The display will alert you to
try again or connect automatically.
7. The appliance is ready to connect to the app.
8. Follow the instructions of the app on your mobile
device for automatic network registration.
The process for registering is completed once “PAIRING
SUCCESSFUL” is shown in the display.
Remote Start
9 WARNING
REMOTE OPERATION
This appliance is configurable to allow remote
operation at any time. Do not store any flammable
materials or temperature sensitive items inside, on
top or near surface units of the appliance.
If you want to start an oven operation using your mobile
device, you must activate Remote Start.
Notes
▯
For some models a permanent Remote Start can be
activated via the Home Connect app. This function
allows a remote start of the available operating modes
without automatically deactivating Remote Start.
▯
“Remote start” can only be activated if the Home
Connect set-up has been successfully completed.
▯
Some operating modes can only be started on the
oven itself.
1. Press the “Remote start” touch button.
2. F appears in the display.
Remote Start is automatically deactivated in the
following situations:
▯
Every time the oven door is opened.
▯
24 hours after Remote Start has been activated.
When you start the oven operation on the appliance,
Remote Start is automatically activated. You can
therefore make changes from your mobile device or
start a new operation.
Home Connect Settings
You can adjust Home Connect to suit your requirements
at any time.
Wi-Fi
You can use the Home Connect functions, if Wi-Fi is
activated.
1. Press the Settings touch button repeatedly until
“HOME CONNECT SETUP” is displayed.
2. Press Enter.
3. Press the Settings touch button repeatedly until “WI-FI
ON” or “WI-FI OFF” is displayed
4. Press Enter.
5. Press “0” for turning Wi-Fi off, or “1” for turning Wi-Fi
on..
6. ”DEACTIVATING WI-FI” or ”ACTIVATING WI-FI” is
displayed.
Disconnecting from the Network
You can disconnect your oven from the network at any
time.
Note: If your oven is disconnected from the network, it is
not possible to operate the oven using Home Connect.
1. Press the Settings touch button repeatedly until
“HOME CONNECT SETUP” is displayed.
2. Press Enter.
3. Press the Settings touch button repeatedly until
“NETWORK CONNECTED” is displayed
4. Press Enter.
5. “PRESS 0 TO DISCONNECT” is displayed.
Press “0”.
6. ”DELETING NETWORK” is displayed.
Connecting to the network
Connecting to the network
1. Press the Settings touch button repeatedly until
“HOME CONNECT SETUP” is displayed.
2. Press Enter.
“PRESS ENTER FOR HC” is displayed.
3. Press Enter to start Home Connect assistant.
4. Follow the instructions in the section entitled “Manual
registration in the home network” or “Automatic
registration in the home network”.