Eclipse - Fujitsu Ten CD5435 - Manual (Page 19)

19
ESN security operating procedure
How to operate the ESN (Key CD) security
How to program the Key CD
Check that the unit is in standby.
Press and hold button [6], then the [FUNC] button,
and hold both for more than one second.
A [SEC] message appears, in two seconds it will change to
[DISC].
Press the [CD ] button.
The front panel opens; The CD5435 is now ready for your Key
CD in the CD slot.
Insert the CD into the slot.
A [SEC] message appears, then the Key CD is ejected.
Press the [CD ] button.
The front panel closes.
● If a CD has already been inserted, a [SEC] message appears,
and then the front panel opens and the CD is ejected.
● If a security is activated, programming the Key CD is not
available.
● If there is a problem with the inserted CD, an [ERR] message
will appear for two seconds and the CD will be ejected. Reinsert
the ejected CD.
● If a CD causes the [ERR] message to appear twice in a row, a
[CHANGE] message will appear for two seconds. Try another CD.
● Copy Protected CD and MP3/WMA CD-ROM cannot be programmed for
Key CD security.
● The Security indicator will flash whenever the vehicle's ignition
is switched off.
Button [6]
[FUNC] button [CD ] button
CD5435.book 19 ページ ２００４年１２月１１日 土曜日 午後５時２９分