Eclipse - Fujitsu Ten CD5435 - Manual (Page 117)

117
Mounting instruction
Names of lead wires and destinations
(refer to Page 119)
● Caution ●
Never connect the power supply to the speaker leads, otherwise it
causes damage to the main unit.
● Note ●
To prevent unconnected leads from shorting out, insulate them by
wrapping their tips with electrical tape. Similarly, insulate the ends
of connected leads.
If an external amplifier is to be connected to the receiver, be sure
to ground its outside housing to the vehicle body (a metal part).
No. Name Wire color Destination
1 ACC Red Connect where the power comes
on when the ignition is in the
ACC position.
2 B+ Yellow Connect where the power is
constantly available, regardless
of the ignition switch's position.
3 Ground Black Connect where good body
grounding is available.
4 Antenna power supply Blue Connect to the automatic-antenna
control terminal of the vehicle.
5 Illumination power
supply Orange/white Connect to where power comes on
when the headlights are turned on.
6 Control power supply Blue/white Connect to the control terminal
for the external amplifier, etc.
7 E-LAN terminal Connect to the E-LAN terminal of
the CD changer, etc.
8 & 9 Line-out terminals Connect to the RCA input
connectors of an external
amplifier.
10 Line-out terminals (Nonfader) Connect to the RCA input
connectors of an external
amplifier, or to the RCA output
connectors of a EQ.
11 Speaker leads Connect them to their respective
speaker leads.
12 AUX in terminals Connect to the RCA output
connectors of an external products.
13 Genuine steering remote
control terminal Connect to the vehicle steering
remote control.
* Compatibale vehicle models
for installation : Vehicle with
voltage detection-type steering
remote control. Ask your
dealer for details.
CD5435.book 117 ページ ２００４年１２月１１日 土曜日 午後５時２９分