Fulgor Milano 30 Inch Over-the-Range Microwave Oven Use and Care Manual - Manual (Page 12)

EN
12
This section includes useful information about oven
operation.
1. Plug power supply cord into a standard 3-pronged
15 Amp 120V AC 60Hz power outlet.
2. After placing the food in a suitable container, open the
oven door and put it on the glass tray.
The glass tray and roller guide must always be in place
during cooking.
3. Close the door. Make sure that it is firmly closed.
4. The oven light is on when the microwave oven is
operating.
5. The oven door can be opened at any time during
operation by pushing the door open button of the control
panel. The oven will automatically stop.
6. Each time a pad is pressed, a beep will sound to
acknowledge the press.
7. The oven automatically cooks on full power unless set
to a lower power level.
8. The display will show “ : 0” when the oven CLOCK is
not set.
9. Time clock returns to the present time when the cooking
time ends.
10. When the STOP/CLEAR pad is pressed during oven
operation, the oven stops cooking and all information
is retained. To erase all information (except the present
time), press the STOP/CLEAR pad once more. If the oven
door is opened during oven operation, all information
is retained.
11. If the START pad is pressed and the oven does not
operate, check the area between the door and door
seal for obstructions and make sure the door is closed
securely. The oven will not start cooking until the door
is completely closed or the program has been reset.
Make sure the oven is properly installed and plugged
into the electrical outlet.
5 - OPERATION PROCEDURE
To Set Power Level
The power level is set by pressing the POWER LEVEL pad
and number pad. If you wish to use a different power level,
press the POWER LEVEL pad before pressing START pad.
Enter the power level desired by pressing the appropriate
number pad. The chart shows the display, the power level
and the percentage of power.
PRESS POWER LEVEL
PAD AND NUMBER
POWER LEVEL
(DISPLAY)
APPROXIMATE
PERCENTAGE
OF POWER
Power Level + 1 + 0 PL10 100%
Power Level + 9 PL-9 90%
Power Level + 8 PL-8 80%
Power Level + 7 PL-7 70%
Power Level + 6 PL-6 60%
Power Level + 5 PL-5 50%
Power Level + 4 PL-4 40%
Power Level + 3 PL-3 30%
Power Level + 2 PL-2 20%
Power Level + 1 PL-1 10%
Power Level + 0 PL-0 0%
NOTE: If “PL-0” is selected, the oven will work with the
fan but no power. You can use this level to remove odors.
1_TINSKB286MRR0_FULGOR _OTR_U&C_.indd 12 7/9/19 9:25 AM