Extron Electronics CSVEQ 100 D - Manual (Page 6)

CSVEQ 100 D • Quick Start Guide
Quick Start — CSVEQ 100 D, cont’d
QS-2
When using long cables, follow these steps:
a
. Supply the color bars test signal to the input. (Recommendation:
use an Extron VTG 300 Video Test Generator to generate the test
signal.)
b . Adjust the Gain control(s) for the output until the signal level
at the far end is the same as the input (or the display shows the
correct brightness and contrast).
c . Adjust the EQ control for the output so that no overshoot or
round front corner appears at the far end on the oscilloscope or
you see a sharp picture with no smearing.
Step 7
See "Installation Instructions" in chapter 2 for further installation
details.