Christie DWU1075-GS 10,875-Lumen WUXGA 1DLP Laser Phosphor Projector with BoldColor Technology (No Lens) - Manual (Page 8)

GS Series 1075 User Manual 8
020-001225-04 Rev. 1 (10-2018)
Safety
Read all safety and warning guidelines before installing or operating the projector.
This projector must be operated in an environment that meets the operating range specification.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in
the risk of fire, shock, or personal injury.
.
Warning! Failure to comply with the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The bright light may result in permanent
eye damage.
• To reduce the risk of fire or electric shock, do not expose this projector to rain or moisture.
• Do not open or disassemble the projector as this may cause electric shock.
• All installation and maintenance procedures must be performed by a Christie qualified technician.
• Keep all combustible material away from the concentrated light beam of the projector.
• Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
• Always power down the projector and disconnect all power sources before servicing or cleaning.
• Disconnect the power plug from the AC outlet if the product is not being used for an extended
period of time.
• Only use the AC power cord supplied. Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range for your region.
• Do not allow anything to rest on the power cord.
• Do not block the ventilation slots and openings on the projector.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Only Christie qualified technicians are permitted to open product enclosures.
• FIRE HAZARD! Do not use a power cord or that appears damaged.
• FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
Notice. Failure to comply with the following may result in property damage.
• Use a soft cloth moistened with a mild detergent to clean the display housing.
• Remove the lens plug from the lens opening in the projector before installing the lens. Retain the
lens plug to protect the optical components from dust and debris during transport.
• Do not use abrasive cleaners, waxes, or solvents to clean the projector.
A35LS_UM_English.book Page 8 Thursday, October 25, 2018 5:15 PM