Eagle Electronics FishElite 642c - Manual (Page 147)

139
the arrow keys — S TEER WITH A RROWS
command — or by setting the track
and speed in the dialog boxes provided on the simulator menu screen.
To get to the GPS Simulator:
1. Press
MENU | MENU |
↓ to
GPS S ETUP
| ENT .
2. Press
↓ to
GPS S
IMULATOR
| ENT . The GPS Simulator Menu appears.
GPS Setup Menu (left). GPS Simulator menu (center).
Map Page showing Steer with Arrows dialog boxes (right). The trav-
eler is following a track of 144º at a speed of 71 miles per hour.
Choose the desired settings, then turn on the simulator by highlighting
the
GPS S
IMULATOR
O
N
box and pressing ENT . Press EXIT repeatedly to get
back to the main page display. A message and tone appear periodically
to remind you the simulator is on. To turn off the simulator, repeat the
steps above or turn off the unit.
If you selected the Steer with Arrows command and want to remove the
dialog boxes from the screen, press
EXIT . That will clear the track and
speed boxes without disrupting the simulation and allow you to use the
map cursor.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a S TARTING P O-
SITION
at or near the beginning of your trail/route. Enter an approximate
T RACK
(shown in compass degrees) that will point you toward the start
of the trail/route.
2. Set S PEED
to zero. Select S TEER WITH A RROWS
command and press ENT ,
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-