Eagle Electronics FishElite 642c - Manual (Page 123)

115
1. Insert the MMC into your unit. Press MENU | MENU |
↓ to
S
YSTEM
S
ETUP
| ENT |
↓ to
T
RANSFER
M
Y
D
ATA
| ENT .
2. The Transfer My Data menu includes a message which tells you if an
MMC is present or not. If no MMC is present, you must insert a card
into the unit to activate the Load or Save commands.
To transfer data from the unit to the MMC: press ENT (for S AVE
.)
To transfer data from the MMC to the unit: press
→ to
L
OAD
| ENT .
3. Saving to MMC: To accept the default name "Data" for the GPS
Data File, press
↓ to
S
AVE
D
ATA
| ENT . If you want to rename the file (as
shown in the following figures), press ENT to activate the selection box.
Press
↑ ↓ to change the first character, then press → to the next char-
acter and repeat until the name is correct. Then press ENT |
↓ to
S
AVE
D ATA
| ENT .
The unit will display first a progress then a completion message when
the data transfer is finished. To return to the Page view, repeatedly
press
EXIT .
These figures (from left to right) show the menu sequence for naming
and saving a GPS Data File from the unit's memory to an MMC.
4. Loading to unit memory: There may be more than one GPS Data
File (*.USR) on the card. To select a file, press
ENT to activate the selec-
tion box, use
↓ ↑ to highlight the file, then press
ENT to accept the se-
lection. Next, press
↓ to
L OAD D ATA
| ENT . The unit will display a comple-
tion message when the data transfer is finished. To return to the main
page display, press
EXIT repeatedly.