CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects - Manual (Page 33)

Page 27 GigBAR MOVE + ILS User Manual Rev. 3
Operation
Master/Slave Mode
The Master/Slave mode allows a single GigBAR MOVE + ILS product (the “master”) to control the actions
of one or more GigBAR MOVE + ILS products (the “slaves”) without the need of a DMX controller. The
master product will be set to operate in either standalone mode or with the RF remote, whereas the slave
products will be set to operate in slave mode. Once set and connected, the slave products will operate in
unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press repeatedly until SETUP shows on the display, then press .
2. Use or to select DFI , then press .
3. Use or to select ON , then press .
4. Use or to select the receiving D-Fi channel, from 1–16.
5. Press .
6. Press repeatedly until SLAVE shows on the display, then press .
7. Finish setting and connecting all the slave products.
Master product:
1. Press repeatedly until SETUP shows on the display, then press .
2. Use or to select DFI , then press .
3. Use or to select ON , then press .
4. Use or to select the transmitting D-Fi channel, from 1–16.
5. Press .
• Make sure that the slave products are configured to the same D-Fi channel as the
master product.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.