CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects - Manual (Page 31)

Page 25 GigBAR MOVE + ILS User Manual Rev. 3
Operation
GigBAR RF Remote Control
The GigBAR MOVE + ILS can be operated with the GigBAR RF Remote. To enable RF wireless control,
follow the instructions below.
GigBAR RF Remote Operation
1. Press to view the main menu on the display.
2. Use or until SETUP is selected.
3. Press .
4. Use or until RF is selected.
5. Press .
6. Use or to select COMMON (to connect a
GigBAR MOVE + ILS to any RF remote) or BIND (to pair an RF remote
to a specific GigBAR MOVE + ILS fixture).
7. Press .
Black Out
To black out the lasers with the RF remote:
• Press on the RF remote.
This will turn off all the lasers until the button is pressed again.
NOTE: The RF remote will not respond to any inputs when Black Out is
activated. If the product does not respond when a button is pressed, try
pressing . Black Out may have been activated.
Strobe
To activate strobe in manual mode using the RF remote:
1. Press on the RF remote.
2. Press <+> or <–> to adjust the strobe.
Dimmer
To adjust the dimmer using the RF remote:
1. Press on the RF remote.
2. Press <+> or <–> to adjust the brightness.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode with the RF remote:
1. Press on the RF remote.
2. Press <+> or <–> to choose between the different auto programs.
Speed
To adjust the auto program/spot speed with the RF remote:
1. Press on the RF remote.
2. Press <+> or <–> to increase or decrease the program speed.
Sound-Active Mode
To turn on Sound-Active mode with the RF remote:
1. Press and hold on the RF remote.
2. Press <+> or <–> to select a sound-active program.
To adjust the sound sensitivity:
1. Press on the RF remote.
2. Press <+> or <–> to increase or decrease the sensitivity.
Freeze
To pause an auto program using the RF remote:
1. Press on the RF remote.