CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects - Manual (Page 21)

Page 15 GigBAR MOVE + ILS User Manual Rev. 3
Operation
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Automatic Mixed Effect Mode
To run the GigBAR MOVE + ILS in automatic mode, follow the instructions below.
1. Press to view the main menu on the display.
2. Use or until AUTO is highlighted.
3. Press .
4. Use or to select Program .
5. Press .
6. Use or to select from the Auto Program options: Mix 1–4 , Spots , Strobe , Laser ,
Derby , Par , S+SP , L+SP , LS , D+SP , DS , DL , P+SP , PS , PL , PD , PS+SP , PL+SP , PLS , PD+SP ,
PDS , PDL , DLS+SP , PLS+SP , PDS+SP , PDL+SP , or PDLS .
7. Press .
8. Use or to select Mode .
9. Press .
10. Use or to select between Snap (snap transition between programs) and Fade
(fading transition between programs).
11. Press .
12. Use or to select Speed .
13. Press .
14. Use or to select to adjust the program speed, from 0 – 99 .
15. Press .
Sound-Active Mixed Effect Mode
To run the GigBAR MOVE + ILS in sound-active mode, do the following:
1. Press to view the main menu on the display.
2. Use or until SOUND is selected.
3. Press .
4. Use or to select Program .
5. Press .
6. Use or to select from the Auto Program options: Mix 1–4 , Spots , Strobe , Laser ,
Derby , Par , S+SP , L+SP , LS , D+SP , DS , DL , P+SP , PS , PL , PD , PS+SP , PL+SP , PLS , PD+SP ,
PDS , PDL , DLS+SP , PLS+SP , PDS+SP , PDL+SP , or PDLS .
7. Press .
Sound Sensitivity
To set the sound sensitivity on the GigBAR MOVE + ILS, follow the instructions below:
1. Press to view the main menu on the display.
2. Use or until SOUND is selected.
3. Press .
4. Use or to select Sensitivity .
5. Press
6. Use or to set the sound sensitivity from 0–99 .
7. Press .
Dimmer
To adjust the dimmer on the GigBAR MOVE + ILS, do the following:
1. Press to view the main menu on the display.
2. Use or until AUTO or SOUND is selected.
3. Press .
4. Use or to select Dimmer .
5. Press .
6. Use or to set the dimmer from 0–255 .
7. Press .
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
• The product will only respond to low frequencies of music (bass and drums).
• The laser will black out when in Sound-Active mode after 3 seconds of silence or noise
below the sensitivity setting.