CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects - Manual (Page 20)

Page 14
Operation
GigBAR MOVE + ILS User Manual Rev. 3
DMX
DMX
3CH
Selects the DMX channel 28CH
50CH
Address 001–510 Sets DMX starting address
Slave Sets the fixture on Slave mode
SETUP
RF
COMMON Enables control of the fixture using any RF remote
BIND
Enables control of the GigBAR MOVE + ILS using
only the RF remote paired to the fixture
OFF Turns infrared off
RF Binding
Pairs an RF remote to a specific GigBAR MOVE + ILS
fixture
(Hold and press Blackout button on the RF remote)
FOOT
COMMON Enables control of the fixture using any footswitch
BIND
Enables control of the GigBAR MOVE + ILS using
only the footswitch paired to the fixture
OFF Turns footswitch control off
FOOT Binding
Pairs a footswitch to a specific GigBAR MOVE + ILS
fixture
(Hold and press Blackout pedal on the footswitch)
DFI
ON Enables DFI connection
OFF Disables DFI connection
DFI CH 1–16 Selects DFI channel
Pan1 Reverse
ON
Enables/disables Spot 1 pan reverse
OFF
Tilt1 Reverse
ON
Enables/disables Spot 1 tilt reverse
OFF
Pan2 Reverse
ON
Enables/disables Spot 2 pan reverse
OFF
Tilt2 Reverse
ON
Enables/disables Spot 2 tilt reverse
OFF
RESET
NO
Resets to factory defaults
YES
• The DMX value will display in white if not receiving the DMX signal, and will display in
yellow if receiving the DMX signal.
• The menu display will turn off if there is no operation within 60 seconds.
• In DMX mode, the fixture will save the last settings when the DMX signal was lost. When
in Master/Slave mode, it will blackout when the DMX signal is lost.
Mode Programming Levels Description