CHAUVET DJ GigBAR Move + ILS 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects - Manual (Page 22)

Page 16
Operation
GigBAR MOVE + ILS User Manual Rev. 3
Strobe
To set the strobe on the GigBAR MOVE + ILS, follow the instructions below:
1. Press to view the main menu on the display.
2. Use or until AUTO or SOUND is selected.
3. Press .
4. Use or to select Strobe .
5. Press .
6. Use or to set the strobe from 0–20 .
7. Press .
Program Time
To set the program time on the GigBAR MOVE + ILS, do the following:
1. Press to view the main menu on the display.
2. Use or until AUTO or SOUND is selected.
3. Press .
4. Use or to select Program Time .
5. Press .
6. Use or to set the timer from 0–255 (seconds).
7. Press .
Configuration (DMX)
The GigBAR MOVE + ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website:
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf .
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product’s channels could be restricted.
The GigBAR MOVE + ILS uses 3 DMX channels, which defines the highest configurable address to 463 .
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com .
To select the starting address, do the following:
1. Press to view the main menu on the display.
2. Use or until DMX is highlighted.
3. Press .
4. Press again.
5. Use or to select the DMX Channel: 3CH , 28CH , or 50CH .
6. Press
7. Use or to select Address .
8. Press
9. Use or to increase or decrease the starting address.
10. Press .