Epson MOVIEMATE 72 User Manual
Page 59
Problem Solving
59
You see the message
No Signal
.
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 23).
■
Press the
button on Epson MovieMate or the remote control to select the external
video source. Allow a few seconds for Epson MovieMate to sync up.
You see the message
Signal not supported.
Press the
button on the remote control and check the
Video Signal
setting (see
The picture is cut off (too large) or too small.
Press the
button on the remote control and select the appropriate aspect ratio.
Press the
button on the remote control and select the appropriate zoom setting.
The picture is distorted.
■
If you’re using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 56 and 57.
The colors are not right.
■
Press the
button on the remote control and check the
Video Signal
setting (see
■
Press the
button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
or
Tint
settings. See page 41.