LulzBot TAZ Pro S 3D Printer User Manual
Page 26
24 |
LulzBot TAZ Pro S
5.7
Feed the included sample coil
of 1.75mm PLA filament into and
through the bottom of the LulzBot
Green filament sensor marked 1.
Note that Sensor 1 is used when your TAZ Pro S is equipped with a single extrusion tool head. Filament sensors
1 and 2 correspond to Extruder 1 and Extruder 2 on Dual Head equipped models of the TAZ Pro. Each filament
sensor must go to the correct extruder in order for your TAZ Pro S to function properly.
i
5.8
The rear black filament sensor
marked 2, is only used with the TAZ
Pro Dual Extruder option.
5.7
5.8