LulzBot TAZ Pro S 3D Printer - Manual (Page 24)

22 | LulzBot TAZ Pro S
5.5 Remove the blue tape holding
the filament holders in place along
the right side of the printer and
rotate one down into place. Once
in position, place the included PLA
filament on the filament holder.
The filament holders may need
to be adjusted to accommodate
larger spools of filament. Use
the included 4mm hex key to
loosen the screw at the base of
the filament holder, move it to
the appropriate position, and
re-tighten.
i