GeChic 1102I 11.6" 16:9 Portable Touchscreen LCD Monitor - Manual (Page 23)

Problem Solutions
No image shown or "No
Signal " warning, or Power
On/Off Indicator won't turn
on.
1. Check whether if the Power On/Off Indicator showing
green light or not. If not, it indicates there is no power
inputted, please connect to power.
2.Check whether if the HDMI cable has been firmly
connected to On - Lap monitor's HDMI port.
Randomly no display or go
blank Or showing
"Insufficient Power Warn-
ing" on the monitor
1.Please avoid pulling the cables.
2.Please connect to a 5V - 2A adapter to ensure the
power supply is enough.
3.Lower the volume and the brightness. High volume
and brightness may increase power consumption and
cause the monitor going off.
4.Please connect to 5V 2A adapter in case the possibility
of insufficient power of On - Lap 1102H.
Monitor shows image,
but No Sound coming
out.
1. Please select audio output device, "On - Lap monitor,"
at "Playback" at "Sound" in operating system's audio
settings.
2. Please check whether "Mute" has been turned on or not at
volume settings.
3. The earphone jack can only output sound through a earphone
cable, and cannot deliver sound when directly connecting to
computer's audio cable.
Why I cannot set extend
mode and vertical mode
with my desktop/laptop ?
If your desktop/laptop doesn't have the options such as
"Duplicate these displays", "Extend these displays" or
"Portrait ", it indicates your desktop/laptop graphic card
may be limited or may need to update the graphics
driver. Please contact the desktop/laptop manufacturers
or graphics chip manufacturers for technical support.
Why my monitor shows
Out of Range?
It means the video source inputted is not in On - Lap's
supported video input formats, and the monitor cannot
display the resolution or the frequency normally. Please
check On - Lap's supported operating modes.
On - Lap 1102H's charging
bar does not increase; not
be fully charged; battery
takes too long to charge;
the power indicator does
not on.
Please turn off the monitor and connect to GeChic USB
cable and 5V 2A adapter. When the "blue" light is on, the
charging begins. (Please refer to Chapter 3, Section 3.)
The monitor gets darker or
brighter automatically
Please turn off "Auto Contrast Adjust" or "Auto Brightness
Adjust."
The brightness has been set
down, but the screen
brightness does not de-
crease.
GeChic Corporation
5F - 3, No. 138, Zhongming S. Rd.,
West Dist., Taichung, Taiwan (R.O.C.)
Customer Service ： [email protected]
Rev ： 2017/12/22
17