GeChic 1102I 11.6" 16:9 Portable Touchscreen LCD Monitor User Manual
Page 20
14
Chapter 5 Using Touch Monitor (Only for 1102I)
Section 1 Notices
1. Computer with operating system of Windows
10/7 supports On
-
Lap 1102I's touch function.
If computer does not be equipped with Win-
dows 10/7, it may not be able to use On
-
Lap
1102I's touch function. Please be noticed
whether the computer's operating system
supports an external touch monitor.
2. As the fig., USB power & touch cable
①
can
transmit both power and touch signal at the same time;
②
only can trans-
mit power. If
①
connector does not connect to computer's USB port , then
touch function will be no longer available.
Section 2 Windows 10/7 Touchscreen Settings
If your computer does not enable touch screen function automatically or rec-
ognize multi
-
screen, then touch screen will not sense touch position accurate-
ly. Please use Windows 10/7 "Tablet PC Settings" of Control Panel to start
touch screen settings.
In Windows 10
, search "Calibration" at 'Settings', then select "Calibrate the
screen for pen or touch input."
In Windows 7
, select "Tablet PC Settings" at
Control Panel to start touch settings.
As the fig. below, please select "Settings (S)", and follow Windows on
-
screen
instructions to calibrate the touch points on On
-
Lap 1102 to complete touch
settings.