Epson 24-PIN DOT MATRIX PRINTER LQ-570+ - Manual (Page 29)

Testing the Printer
Before connecting your printer to a computer, use the built-in
self-test function to see that the printer is working properly.
Before running the self test, you need to plug your printer's
power cord into an electrical outlet.
Plugging in the printer
1. Make sure the printer is turned off.
2
Check the label on the back of the printer to make the
voltage by the printer matches that of your
electrical outlet.
the voltage and your outlet match,
3.
If the power cord is not to the printer, connect it to
the AC inlet on rear
4. Plug the power cord into a
outlet.
Running the self test
You can run the self test with either paper or single
mar, or bottom. The following steps describe how to run
the test on
single-sheet paper, the top. Chapter
2
for full details on paper handling.
Setting Up the Printer 1-9