Epson 24-PIN DOT MATRIX PRINTER LQ-570+ - Manual (Page 24)

Never use a stand that tilts the printer at an angle of more
than 15 degrees from If you install a cut-sheet
feeder, the stand must keep your printer
If you plan to load continuous paper through the bottom of
the printer, choose a stand that provides an unobstructed
Position your power and interface cable so
they do not interfere with paper feeding. If possible, secure
the cables to a leg of the printer stand.
Align the paper stack so that the paper feeds straight into
the
sprocket units.
Assembling the Printer
Removing the protective materials
During shipping, several pieces of packing material the
printer. Before you assemble the printer, you must
these as shown in the attached Notice
Note:
Installing the ribbon cartridge
Before the ribbon cartridge, make that the
power cord is
not
plugged into an
1-4 Setting Up the Printer