Epson 4000 - Manual (Page 58)

S/MM configurations (continued)
BANK 0 BANK 1 Total memory
16MB 32MB 48MB
32MB X 32MB
32MB 1MB 33MB
32MB 2MB 34MB
32MB 4MB 36MB
32MB 8MB 40MB
32MB 16MB 48MB
32MB 32MB 64MB
Use only tin-plated, 32-bit or 36-bit, 72-pin, fast-page mode
SIMMs that operate at an access speed of 80ns (nanoseconds)
or faster. Be sure all the SIMMs operate at the same speed.
SIMMs that are 80ns must operate with 1 wait state; 70ns or
faster SIMMs can operate with 0 wait state. (To add a wait state,
select
the
DRAM
wait state option from the Advanced
Chipset Control
option in SETUP.)
Inserting SIMMs
Make sure the computer is turned off and then follow these
steps to install SIMMs:
1. Make sure the front of the computer is facing you.
2. Refer to the illustration on page 4-5 to locate the SIMM
sockets on the right side of the system board.
3. Remove any option cards that may be blocking your access
to the SIMM sockets. (See page 4-18 for instructions.)
installing
and Removing Options 4-11