Sony FE 70-200mm f/4 G OSS Lens - Manual (Page 25)

25
Controls
Messages
The following messages appear in the message display
window on the rear of the projector.
Error messages also appear under [Warning Info] in the
main screen of SRX Controller.
Projector (rear)
Error messages are separated into the following three
categories based on severity.
If an error occurs, a message number and error message
appear in the display window.
Error (severity: high): The projector will be shut down
forcibly.
Warning (severity: medium): Operation will continue,
but the problem should be resolved as soon as
possible.
Info (severity: low)
If an error message appears, contact your dealer or your
local Sony representative with the message number and
error message.
Error (severity: high)
The image lags
or is frozen, or
the angle of
view is
incorrect. A setting other than
[Auto] is selected
under [SIGNAL
FORMAT SETTING]
of the [SCREEN
CONTROL] block
and the input signal
does not match. Reconfigure the
[SIGNAL FORMAT
SETTING] settings to
match the input signal, or
select [Auto] (page 17).
The image is
dark. The contrast and
brightness settings
are incorrect. Specify the correct
[Contrast] and
[Brightness] in the
[PICTURE CONTROL]
tab (page 20).
The lamp output
setting is incorrect. Specify the correct
[LAMP POWER] in the
[INSTALLATION] tab
(page 22).
Symptom Cause Solution
The main
screen of
SRX
Controller
does not
appear. The projector and
controller PC are not
connected properly. Connect the connection
cables properly
(page 12).
Symptom Cause Solution
Message No. Message
Error 1 PW_MAIN_SY12
Error 2 PW_MAIN_SY26
Error 3 PW_MAIN_SY7-1
Error 4 PW_MAIN_SY7-2
Error 5 PW_MAIN_FE3.3
Error 6 PW_MAIN_FE2.5
Error 7 PW_MAIN_FE1.8
Error 8 PW_MAIN_FE1.2MX
Error 9 PW_MAIN_FE1.0MX
Error 10 PW_MAIN_FE1.2IN
Error 11 PW_MAIN_FE1.5DC
Error 1
PW_MAIN_SY12
Message number
Message