beautypg.com

Picture control] tab – Sony FE 70-200mm f/4 G OSS Lens User Manual

Page 20

background image

20

[PICTURE CONTROL] Tab

You can select the input signal and adjust the picture
quality in the [PICTURE CONTROL] tab.

[Input Source]

[Signal Mode]

Select the type of signal that is input from the device
connected to the input board.

[D Range]

Set the dynamic range to [Full Range], [Limited Range], or
[Auto].
[Limited Range] assumes that the signal includes restricted
codes, and performs adjustments so that data values 64 to
960 are at a 0% to 100% image levels in the case of a 10-bit
signal. When the signal includes restricted codes, select
[Limited Range].

[I/P Mode]

Select the I/P conversion mode.
Select [Auto Interlace] or [Auto PsF] depending on the
signal source.

[Signal Info]

Displays the horizontal and vertical frequencies
automatically. The values are rough estimates.
The input signal type is displayed under the frequency
values.

[fH]:

Displays the horizontal frequency.

[fV]:

Displays the vertical frequency.

Notes

If [Single 3D] is selected for [INPUT SELECT], signal
information will not be displayed in the right eye settings
if it is common to the left eye settings.

[Signal Adjust]

Adjust the picture quality of the input signal.
Click [+] to increase a setting value, and click [–] to
decrease it.
Clicking the [RESET] button restores all the setting values
below it to their default values.

[Contrast]

Adjust the contrast.
Increasing the value increases the contrast.

[Brightness]

Adjust the brightness.
Increasing the value increases the brightness.

[Color]

Adjust the color density.
Increasing the value increases the color density.

Notes

If [Single 3D] is selected for [INPUT SELECT], items will
not be displayed in the right eye settings if they are
common to the left eye settings.