Sony FE 70-200mm f/4 G OSS Lens - Manual (Page 12)

12
6
When the following screen appears, click [Finish].
If you selected the [Launch the program] checkbox,
SRX Controller will start immediately.
This completes installation of SRX Controller.
When SRX Controller is installed, the “Start SRX
Controller for SRX-T series” icon is created on your
desktop.
Connecting the Controller
PC
Connect the controller PC to the NETWORK connector or
RS-232C connector on the projector, depending on your
operating environment.
Notes
If both the NETWORK connector (LAN) and the RS-232C
connector (COM) are connected at the same time,
communication errors may occur. Use only one connection
at a time.
Connecting to the NETWORK
Connector
Use a LAN cable (not supplied) to connect the
NETWORK connector on the projector to the LAN
connector on the controller PC.
You can also use a LAN cable (straight) (not supplied) and
connect to a network via a hub.
to NETWORK
connector
LAN cable (crossover cable)
(not supplied)
Controller PC
to LAN connector