Sony BRAVIA FW-98BZ50L 98" UHD 4K HDR Commercial Monitor - Manual (Page 42)

42
2
Press the SHUTTER button F .
The next to the shutter speed value
disappears, and the shutter speed value
is highlighted.
3
Adjust the value using the manual
lever
D .
Selection range:
When [60i] is selected:
You can select from 1/8 to 1/10000 (1/6
to 1/10000 when shooting with 24p).
When [50i] is selected:
You can select from 1/6 to 1/10000.
The denominator of the set shutter speed
appears on the LCD screen. For
example, [100] appears on the LCD
screen when you set the shutter speed to
1/100 second. The larger the value on
the LCD screen is, the faster the shutter
speed is.
z Tips
• It is difficult to focus automatically at a lower
shutter speed. Manual focusing with your
camcorder attached to a tripod is recommended.
• When recording under fluorescent lamps,
sodium lamps, or mercury lamps, the picture
may flicker or change colors, or may have
horizontal bands of noise.
You may be able to improve the situation by
adjusting the shutter speed to 1/50 if the power
frequency of your area is 50 Hz, or 1/60 in a 60
Hz area.
• You can switch the shutter speed display
between seconds and degrees ([SHUTTER
DISPLAY], p. 109).
To adjust automatically
Press the SHUTTER button F while the
shutter speed value is highlighted. The
shutter speed value disappears, or
appears next to the shutter speed value.
You can record a subject clearly by using
the ND filter switch
B when the recording
environment is too bright.
The ND filters 1, 2 and 3 reduce the volume
of light to about 1/4, 1/16 and 1/64,
respectively.
If flashes during the iris automatic
adjustment, set the ND filter to 1. If
flashes during the iris automatic
adjustment, set the ND filter to 2. If
flashes during the iris automatic
adjustment, set the ND filter to 3.
The ND filter indicator will stop flashing
and remain on the screen.
If
flashes, set the ND filter B to
“CLEAR.” The ND filter icon will
disappear from the screen.
b Notes
• If you change the ND filter switch B during
recording, the movie and sound may become
distorted.
• When adjusting the iris manually, the ND filter
icon does not flash even if the light volume
should be adjusted with the ND filter.
• If the camcorder cannot detect the ND filter
position (CLEAR/1/2/3), flashes on the
screen. Make sure that the ND filter is set
correctly.
z Tip
• While recording a bright subject, diffraction
may occur if you close the aperture further
down, resulting in a fuzzy focus (this is a
common phenomenon with video cameras). The
Shutter speed value
Adjusting the light level (ND
filter)
Adjusting the brightness (Continued)