Roland BT-1 Bar Trigger Pad - Manual (Page 5)

5
Settings
The BT-1 can be attached to the hoop (tuning bolt) of a V-Drums mesh pad or your acoustic snare
or tom.
By using the included attachment, you can also attach it to a commercially-available stand (rod
type mount) or to the pad mount of a V-Drums stand.
Attaching the BT-1 to a Drum Hoop
NOTE
When the BT-1 is attached on the hoop of an acoustic drum or V-Drums pad, striking the
BT-1 will cause the drum it is mounted on to sound. If this presents a problem, the BT-1 can
be mounted on a stand (p. 6).
* Depending on the shape of the hoop, it might not be possible to attach the BT-1 correctly (p. 12).
* The BT-1 cannot be attached to the hoop of a bass drum.
* The BT-1 cannot be attached to the PDX-8 or PDX-6.
* In order to attach the BT-1 to a PDX-100 or PD-85, you must first install the spacer (L).
1.
Remove the tuning bolt from the
location where you want to attach the
BT-1.
* If the head is strongly tensioned, slightly
loosen the entire head before you
proceed.
2.
Lay the mounting hole of the BT-1
over the bolt hole of the hoop.
3.
Attach the tuning bolt.
1
3
4.
Adjust the tension of the head.
* Strikes on the BT-1 may affect the tension
of the head.
2