Sony Cyber-shot DSC-RX100 IV - Manual (Page 246)

the image (Ghosting).
When pointing the lens toward the strong light source, excessive light enters the lens and
the image may come out white (flare) or extraneous light (ghost images) may appear on
the image, but this is not a malfunction.
Set up the composition so that you shoot images while avoiding backlit condition.
[297] Troubleshooting Troubleshooting Shooting still images/movies
The image is blurred.
Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-shake. The
use of a tripod or the flash is recommended. [Hand-held Twilight] and [Anti Motion Blur] in
[Scene Selection] are also effective in reducing blur.
[298] Troubleshooting Troubleshooting Shooting still images/movies
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product will automatically
turn off. The product turns on again when you press the power button.
[299] Troubleshooting Troubleshooting Shooting still images/movies
The flash takes too long to recharge.
The flash has been fired in succession in a short period. When the flash has been fired in
succession, the recharging process may take longer than usual to avoid overheating of
the camera.