Canon EOS 1300D - Manual (Page 69)

69
Saving Images
If necessary, also read “NFC Function Cautions” (p.21).
While saving images, a picture cannot be taken even if the camera’s
shutter button is pressed.
Do not drop the camera on Connect Station or touch the camera to it with
too much force. Doing so may damage Connect Station’s internal hard
disk.
If the camera is not recognized right away, try holding it close to Connect
Station and slowly moving it or rotating it horizontally.
Just holding the camera close to Connect Station may not establish a
connection. In such a case, gently touch Connect Station with the
camera.
When holding the camera close to Connect Station, do not leave
anything between the camera and Connect Station. In addition, when a
case is attached to the camera, communication may not be possible via
NFC function.
If the camera and Connect Station are moved too far away from each
other while saving images, saving may take time or the connection may
be terminated.
If the camera’s battery runs out while saving images, the saving will stop.
Charge the battery, then try again.
When all images are already saved, saving will not start. In such a case,
select [OK] to terminate the connection.
When there are a large number of images on the memory card, it may
take time to check and save the images.
While saving images, the camera’s auto power off does not function.