Canon EOS 1300D - Manual (Page 119)

119
Responding to Error Messages
In the case of [q], is Camera Connect running?
X Establish a connection using Camera Connect (p.31).
In the case of [l], is the power of the printer on?
X Turn on the printer.
Are the camera and the access point set to use the same
encryption key for authentication?
X This error occurs if the encryption keys do not match when the
authentication method for encryption is set to [Open system].
The setting is case-sensitive, so check upper- and lower-case
characters. Make sure that the correct encryption key for
authentication is entered on the camera (p.85, 101).
Is the power of the target device and access point on?
X Turn on the target device and access point, then wait a while. If a
connection still cannot be established, perform the procedures to
establish the connection again.
Is the camera too far from the target device or the antenna of
the access point?
X Bring the camera and the target device or the antenna of the
access point closer together.
11: Connection target not found
12: Connection target not found