ProSoft Technology AN-X-MOD - Manual (Page 8)

Page 4 AN-X-MOD (Master) November 2011
Installation
Prevent Electrostatic Discharge
The module is sensitive to electrostatic discharge.
WARNING! Electrostatic discharge can damage integrated circuits or
semiconductors. Follow these guidelines when you handle the module:
• Touch a grounded object to discharge static potential
• Do not touch the connector pins
Power
AN-X requires a DC power input of anywhere from 12 to 24 VDC.
Left to right the pins on the power connector are chassis ground, negative
voltage and positive voltage.
The chassis ground should be connected.
Power consumption is 200 mA @ 12VDC or 100 mA @ 24VDC.
The part number for the power connector is Phoenix MSTB
2.5/3-ST-5.08
S908 Cabling and Termination
Refer to the Modicon Remote I/O Cable System Planning and
Installation Guide 890 USE 101 00 Version 3.0 for detailed information
on cabling and installation.
The module has a standard F connector for connection to the S908
remote I/O network.
AN-X should be connected like any other node. Ensure that the physical
ends of the S908 remote I/O network are properly terminated.
The AN-X module does not connect the S908 cable to earth ground. If a
connection to ground is required, use an F connector grounding block.