ProSoft Technology AN-X-MOD - Manual (Page 47)

AN-X-MOD (Master) Page 43
Parameter Description
DataInput,
arraynamename
both AN-X modules
ClxName ClxName is used in the address part of the aliases
for elements that are unique for each AN-X, such
as diagnostics. It is usually set equal to the
Ethernet host name.
ClxPrefix The ClxPrefix is used in the alias name for I/O
data. It should be the same for both AN-X
modules in a redundant application.
RedundEna
Include a line with the RedundEna parameter, followed by a comma and
a unique name for the AN-X at the start of the ControlLogix
configuration file.
RedundPrefix
AN-X uses the RedundPrefix when it generates aliases for elements that
are unique to each AN-X module, such as diagnostics.
RedundCtl
RedundCtl consists of a single 16-bit word. Only bit 0 is used. To
enable an AN-X to act as the scanner, set bit 0 to 1. To disable the
AN-X, set bit 0 to 0.
Map RedundCtl to the output data for the connection to slot 0 in each
AN-X. If the configuration file contains RedundEna, you must map
RedundCtl.
ScanSts
ScanSts is an array of 5 INTs that contain information about the current
operation of the Modicon S908 network scan.
Offset Description
0 Scan state
0=idle, no packets being received from the S908 network
1=monitor, another master is active
2=scanning
3=scan halted, was actively scanning but the enable bit has
been turned off
1 Scan counter, increments at the start of each S908 network
scan