ProSoft Technology AN-X-MOD - Manual (Page 58)

Page 54 AN-X-MOD (Master) November 2011
You must enter a default gateway address that is valid for the subnet,
even if there is no device at the gateway address on the network.
Click OK to complete the configuration.
Use the Utilities/Restart AN-X to restart the AN-X in production mode.
If you Cancel the Utilities/AN-X IP Configuration command, AN-X is
left running in boot mode. Use the Utilities/Restart AN-X command to
restart the AN-X.
Restart an AN-X
Use the Utilities/Restart AN-X command to restart the currently selected
AN-X in poduction mode.
AN-X Info
The Utilities/AN-X Info command provides information about the
currently selected AN-X in the log window.
The information shown:
AN-X Info Ethernet MAC address
SerNum Serial number
DaughterID Daughterboard ID, 10 for AN-X-MOD (Master)
BootRev Boot code version
ConfigRev Configuration kernel version
ProdRev Production kernel version
HwRev Hardware version
FirmwRev Firmware release version (depends on current
operating mode)
Status see below
VendorId Vendor ID
ProdId Product ID
IpAddrStr AN-X IP address
HostName AN-X host name
In boot mode, FirmwRev, Vendor ID and Product ID and not valid, and
IpAddrStr and HostName are not shown.