ProSoft Technology MVI56E-SIE - Manual (Page 57)

MVI56E-SIE ♦ ControlLogix Platform Configuring the MVI56E-SIE Module
Client Communication Module User Manual
ProSoft Technology, Inc. Page 57 of 168
September 6, 2012
Internal Address
0 to 65535 (for bit-level addressing) or
0 to 4999 (for word-level addressing)
This parameter specifies the database address in the module's internal database
to use as the destination for data brought in by a read command or as the source
for data to be sent out by a write command. The database address is interpreted
as a bit address or a 16-bit word (register) address, depending on the Siemens
Industrial Ethernet
’s Data Type used in the command. If Data Type – Bool is
used in the command list, then the database address will be interpreted as a bit
address. When any other data types are used, then the database address is
interpreted as 16-bit word (register) address.
Poll Interval
0 to 65535
This parameter specifies the minimum interval between issuances of a command
during continuous command execution (Enable code of 1). The parameter is
entered in tenths of a second. Therefore, if a value of 100 is entered for a
command, the command executes no more frequently than every 10 seconds.
Reg Count
Regs: This Count will depend on the Siemens processor type
Coils: This Count will depend on the Siemens processor type
Below are the tables of the max reg count limit for three of the Siemens
processors:
CPU315-2 DP
Data Block:
Address Type Function Data Type Max Reg Cnt Max Reg Cnt
DB READ BOOL 1
Write BOOL 1
READ BYTE 164
Write BYTE
164
READ DINT 41
Write DINT 41
READ REAL 41
Write REAL 41
READ INT 82
Write INT
82
READ TIME 82
Write TIME 41
READ COUNT 82
Write COUNT 82