ProSoft Technology MVI56E-SIE - Manual (Page 151)

MVI56E-SIE ♦ ControlLogix Platform Reference
Client Communication Module User Manual
ProSoft Technology, Inc. Page 151 of 168
September 6, 2012
4 Data received from the server is passed into the module's internal database,
if the command was a read command. General module status information is
routinely returned to the processor in the input images.
5 Status data for a specific Client can be requested by the processor and
returned in a special Client Status block.
6 Special functions, such as Command Control options, can be generated by
the processor and sent to the Client driver for action.
5.2.4 Client Command List
In order for the Client to function, the module's Client Command List must be
defined in the SIE Client x Commands section of the configuration. This list
contains up to 16 individual entries, with each entry containing the information
required to construct a valid command. This includes the following:
 Command enable mode: (0) disabled or (1) continuous
 IP address and service port to connect to on the remote server
 Slave Node Address
 Command Type - Read or Write
 Database Source and Destination Register Address - Determines where data
will be placed and/or obtained
 Count - Select the number of words to be transferred - see reference based
on processor type
 Poll Delay - 1/10 th seconds
For information on troubleshooting commands, see Client Command Errors
(page 130).