PLANET NAS-7450 - Manual (Page 4)

4
Interface Description
Power Button Green(power on), Yellow(default)
LCD Panel Display LAN1/LAN2 IP Information
Control Button Press the Control button to configure LAN1/LAN2 IP address.
LAN1
Yellow(10M link), Green(100M link), Amber(1000M link)
LAN2
HD Access LED HD LED (Power/Fault) Description
Red on Green Blinks Powering up
Red On
during access
Green On HDD is being accessed
Red Blinks (Fast) Green Blinks (Fast)
RAID building, rebuilding,
expanding
Red off Amber on
Volume un-mounted and HDD is
ready for being hot-up plugged
Off Amber Blinks (Slowly)
Disk faulty.
Blinking interval is about 2
seconds
NAS-7450 Rear View
Power Jack
e-SATA
RS-232
LAN Jack
USB
PCI-E
Interface Description
Power Jack
Connect the two power supply cord shipped with the
system
e-SATA Connect to External hard drive case
RS-232 Connect to UPS
LAN Jack (LAN1)
These RJ-45 ports support auto negotiating Fast Ethernet
10/100/1000 Base-TX networks. That allows your system
to be connected to an Internet Access device, e.g.
router, cable modem, ADSL modem, through a CAT.5
twisted pair Ethernet cable.
LAN Jack (LAN2)
USB Socket Connect to UPS and external HDD(FAT/FAT32)
PCI-E Port (optional) Connect to Tape Backup or Tape Library or Network card